Quad Precision VCO Perfect for polyphonic or paraphone patches, Four precision VCOs with output mixers and a master control unit, Waveforms: Triangle, sawtooth and rectangle with individual outputs, Minute 10 octave...
A-110-6 реализован на основе ядра, генерирующего квадратурную трапецию (TRASIN и TRACOS) Cтандартные формы волны (треугольник, синусоида, пилообразные и квадратные) являются производными от этих двух сигналов через Waveshaper. Модуль основан на идее...
Модуль A-165 (Dual Trigger Modifier) содержит два отдельных триггерных модификатора для использования с логическими уровнями (гейт, тактовые сигналы, триггер).
A-172 является модулем, который сравнивает напряжение на четырёх аналоговых входах и выдаёт максимальное и минимальное значение на двух аналоговых выходах
Mini PSU / Backplane Module comes preassembled and tested, +/- 12V @ 200 mA and +5V @ 50 mA, Integrated backplane with 4 slots, Especially for applications with just one or a few modules (max. 200 mA, max. 4 modules),...
Cable Set For DIY Synthesizer kit, Consisting of two 16-pin and five 10-pin flat-ribbon cables, With matching counterparts to the 2-pin contact strips on the DIY Synth board, Length: Each 50 cm, The other end of each...
S-Trigger Cable With built-in S-trigger electronics, Length: 1.2 m, 3.5 mm Mono mini jack plug to 1/4" mono jack, Converts gate to switched trigger (S-trigger)'
Wasp Filter Special edition, Special 12 dB multimode filter, Circuit technology of the "EDP Wasp", Black front, Yellow pot caps, Width: 8 HP, Depth: 45 mm, Power requirements: +30 mA (+12 V)/-10 mA (-12 V)'
Power Adapter 12 V / 2000 mA, -12 V / 1200 mA, 5 V / 4000 mA, 100-230 V ATTENTION - the connection and installation of parts which carry mains voltage (mains input, power supply, connecting cable, etc.) must only be...
Passive Multi-Port Distributor 8x Interconnected jacks, Sockets are divided into 2x quadruple groups- but can also be modified to an eight-multiple (soldering bridge on the circuit board), Width: 2HP
Dual Attenuator Passive attenuator, Level attenuation for voltage controls or audio signals for A-100 modules or modules from other manufacturers without attenuators
Passive Multi-Connector Eight interconnected jacks can be split into 2 groups (solder bridge on the assembly side), Width: 2 HP, Vintage edition with black front plate
Gate / Trigger Combiner Simple, passive module that combines up to 7 gate, trigger or analog signals, Eurorack format, Width: 4 HP, Depth: 20 mm, Power Requirement: + 0mA (+ 12V) / -0mA (-12V)
Multi-Connector (2x 4 multi-port distributors)The A-180 module is a simple, passive multiple distributor. It contains two groups, each with 4 connected sockets, so that you can "multiply" the input or output of a...'
Bus Board Compatible with the Roland AIRA series (requires PSU3 power supply), Bus board (1x), Incl. 4 connection cables with flat connectors, approx. 30 cm in length