Eurorack Module Dual ADSR, Two identical analog envelopes in one module, Per envelope: CV input with attenuator to control any parameter (selectable by jumper), Gate entrance, Retrigger input, 2 Outputs, Voltage range:...
A-110-6 реализован на основе ядра, генерирующего квадратурную трапецию (TRASIN и TRACOS) Cтандартные формы волны (треугольник, синусоида, пилообразные и квадратные) являются производными от этих двух сигналов через Waveshaper. Модуль основан на идее...
Модуль A-165 (Dual Trigger Modifier) содержит два отдельных триггерных модификатора для использования с логическими уровнями (гейт, тактовые сигналы, триггер).
A-172 является модулем, который сравнивает напряжение на четырёх аналоговых входах и выдаёт максимальное и минимальное значение на двух аналоговых выходах
Mini PSU / Backplane Module comes preassembled and tested, +/- 12V @ 200 mA and +5V @ 50 mA, Integrated backplane with 4 slots, Especially for applications with just one or a few modules (max. 200 mA, max. 4 modules),...
Cable Set For DIY Synthesizer kit, Consisting of two 16-pin and five 10-pin flat-ribbon cables, With matching counterparts to the 2-pin contact strips on the DIY Synth board, Length: Each 50 cm, The other end of each...
S-Trigger Cable With built-in S-trigger electronics, Length: 1.2 m, 3.5 mm Mono mini jack plug to 1/4" mono jack, Converts gate to switched trigger (S-trigger)'
Power Adapter 12 V / 2000 mA, -12 V / 1200 mA, 5 V / 4000 mA, 100-230 V ATTENTION - the connection and installation of parts which carry mains voltage (mains input, power supply, connecting cable, etc.) must only be...
Slew Limiter Module Voltage controlled, Applied voltage jump at the input leads to a rising or falling curve whose steepness is controlled with the rate knob, Euro rack format, Width: 8 HP, Depth: 40 mm, Power...
Low Frequency Oscillator 2 With adjustable waveform, 3 outputs, Frequency range selectable, Eurorack format, Width: 8 HP, Depth: 45 mm, Power requirement: +20 mA (+ 12V) / -20 mA (-12V)
Bus Access Module (BAC) An active bus access module (BAC) to feed CV and gate into the bus via a jack plug (ex., with several A-100 racks or an external MIDI-CV / gate interface), Alternatively, the module can also be...
ADSR Envelope Generator The module A-140 is a envelope generator and since it delivers control voltages, belongs to the modulation-modules. As soon as the ADSR is triggered at gate-input, it generates an adjustable...
Euro Rack Module Provides 3 adjustable DC voltages, Adjustable voltage range: 0 - 5 V or -2.5 to 2.5 V, Euro rack format, Width: 8 HP, Depth: 40 mm, Power consumption: +20 mA (+12V)/ -10 mA (-12V)
Multi-Connector (2x 4 multi-port distributors)The A-180 module is a simple, passive multiple distributor. It contains two groups, each with 4 connected sockets, so that you can "multiply" the input or output of a...'
Dual Voltage-Controlled Amplifier Module A-132 contains two voltage-controlled amplifiers with linear characteristic, which are designed mainly to control the amplitude of the control signals, for example: ADSR amount,...
Multiple Distribution Module Passive, Each socket can be switched in 3 variants (1,2, off), 8-Way multipin: all switches on the left or right, Two times 4-fold multipin: four on 1, four on 2, Eurorack format, Width: 6...
Gate / Trigger Combiner Simple, passive module that combines up to 7 gate, trigger or analog signals, Eurorack format, Width: 4 HP, Depth: 20 mm, Power Requirement: + 0mA (+ 12V) / -0mA (-12V)
Bus Board Compatible with the Roland AIRA series (requires PSU3 power supply), Bus board (1x), Incl. 4 connection cables with flat connectors, approx. 30 cm in length
Mixer Module Mixers with logarithmic potentiometers, Primarily for mixing audio signals, Vintage edition with black front panel, Width: 8 HP, Depth: 35 mm, Current consumption: +10mA (+12V) / -10mA (-12V)
Dual sample and hold module Vintage edition with black front plate, Designed to produce 'staircase' voltages, Consists of two separate sample / hold circuits, Eurorack format, Width: 4 HP, Depth: 30 mm, Power...
Combination of power supply and bus board With 8 slots for A-100 modules for max. Total power consumption up to 380 mA, 100-240V AC / 50-60 Hz, IEC power input on the circuit board, Safety protective cover at the...
Envelope generator with one parameter Decay is adjustable manually or via external control voltage, Envelope output is displayed with LED control, Eurorack format, Width: 8 HP, Depth: 40 mm, Power requirements: +40 mA...
Eurorack Module Voltage Addressed Track & Hold / Switch (Multiplexer) / Digital Outputs, Combined electronic 8-way rotary switch- with 8-fold track & hold module, Input and output indicator via LED, 8 Additional...
24 dB Low Pass Filter SSM Based on the chip SSM2044, Width: 8 TE / 8 HP / 40.3 mm, Depth: 45 mm (measured from the rear of the front panel), Power Requirements: 30 mA (12 V) / A -20 m (-12 V)
Eurorack Module Voltage-controlled 24 dB low-pass filter, Cut-off frequency can be set manually or via control voltages, Two CV inputs, Power requirement: +20 mA (+12 V) / -10 mA (-12 V), Dimensions: 8 TE / 8 HP / 40.3...
24 dB Low Pass 1 (VCF1)Module A-120 is a voltage-controlled 24 dB low-pass filter, which filters out the high frequency components from a sound spectrum while allowing the low frequencies to pass unhindered. The cut-off...
Theremin Module Produces variable control voltage when hand is moved around the antenna, Range approx. 30 cm, Maximum output voltage: 10V, Euro rack format, Power requirements: 60 MA (+12 V) / 20 mA -12 V), Width: 8 HP...
Mini-Case With external power adapter, Empty case suitable for up to 4 A-100 modules, Usable width 32 HP (e.g. three modules with 8HP and a module with 4HP), External dimensions (W x H x D): approx. 160 x 155 x 125 mm
24 dB Low Pass 1 (VCF1)Module A-120 is a voltage-controlled 24 dB low-pass filter, which filters out the high frequency components from a sound spectrum while allowing the low frequencies to pass unhindered. The cut-off...
Dual linear/exponential VCA The character of the control scale can be switched to linear or exponential, Can be used to process both audio and control voltages, Black front panel, Width: 8 HP, Depth: 50 mm, Power...
Envelope Generator Parameters can be set independently, 3-Step switch for selecting the time range, Euro rack format, Width: 8 HP, Depth: 50 mm, Power requirements: +20 mA (+12V) / -20 mA (-12V), Black front panel
Voltage Controlled Clock Multiplier Multiplication factor can be controlled by control voltage or a regulator, Black front panel, Width: 4 HP, Depth: 35 mm, Power requirements: +50 mA (+12 V) / -0 mA (-12 V)
Dual Slew Limiter Vintage edition with black front plate, Contains two separate slew limiters, A limiter with one control for attack and release (0-10 seconds), A limiter with separate controls for attack and release,...
Spring reverb module in Eurorack format By way of spiral springs electronically recreates the reverb effect, Spring system with 3 separate springs, Reverb signal can be fed back to the input, Width: 8 HP, Depth: 50 mm,...
Low-Pass Filter 6 / 12 / 24 / 48 dB Module A-108 is a completely new voltage-controlled low pass / band pass filter based on the well-known transistor ladder (Moog ladder). The module has an internal 8-stage low-pass...
Sampler / Wavetable moduleThe A-112 Module is a combined module of a voltage-controlled 8-bit sampler and a wavetable oscillator. Moreover, it is able to produce effects. It is available as a supplemental sound...
Sequencer Controller Module Vintage edition with black front plate, Expansion module for A-155 (Article Nr 154958 ), Different operating modes, LED display, 8 or 16 sequencer steps, Controls up to 2x A-155 (2x A-155...
Octal Voltage Controlled Switch Eight manual or CV controllable switches, Shared output / input (O / I) and two inputs / outputs (I / O1, I / O2) per switch, Functions of inputs and outputs are interchangeable, Two...
Empty Housing for Eurorack Modules Integrated power supply A-100SSB (+ 12V/380 mA, -12V/380mA), 48 HP version of the A-100LC3, Built-in bus board with 8 module slots, IEC socket on the back side, Internal dimensions:...
Multi Type Morphing Filters Expansion module for the A100 Modular system, Width: 26TE / 131.8 mm, Depth: 40 mm (measured from the rear of the front panel), Power requirements: 200 mA (12V) / -60 mA (-12V)
Analogue and Trigger Sequencer Vintage edition with black front plate, 2 Switch rows with 8 steps each, Euro rack format, Width: 50 HP, Depth: 40 mm, Power consumption: +80 mA (+12V)/ -20 mA (-12V)
High End VCO II / VCLFO Switchable between LFO and VCO modes, Extremely precise with extremely wide frequency range and almost perfect waveforms, Width: 14 HP, Depth: 55 mm, Power requirements: +70 mA (+12 V) / -50 mA...
Analog Modular System Base System in LC9 suitcase with PSU3, Format: 9 HE Content of the system: 2 x standard VCO A-110, 1x Ring Modulator A-114, 1 x audio Divider A-115, 1 x VC Waveform Processor A-116, 1 x Noise /...